AUTONET TV

What Is an EGR Valve? (EGR Valve Service)

If you've ever felt your vehicle hesitate, go, then hesitate again, you might think there's something wrong with the transmission.  After all, it's not moving smoothly  down the road.  But there are plenty of malfunctions that can cause those symptoms, one of them being something you may have never heard of: the EGR valve.

EGR stands for Exhaust Gas Recirculation. It's a system that channels small amounts of exhaust back into the engine to cool down the cylinders and reduce polluting gases.  Those include nitrogen oxides that can cause smog. The EGR valve regulates how much of the vehicle's exhaust gas is recirculated. After years and long distances traveled, that valve can get clogged or fail. Sometimes the EGR valve can stick open.  When the EGR valve isn't working properly, your vehicle can start releasing those nitrogen oxides and pollute the air.

The symptoms of a malfunctioning EGR valve include:

• Engine losing power
• Engine idling roughly
• Pinging and knocking sounds in the engine
• Stalling and hesitation
• Fuel economy decreasing
• Check Engine light illuminated

Depending on its condition, the EGR valve can be cleaned or it may need to be replaced.  Consult with your service advisor to see what options are recommended to you.

The EGR system is part of your vehicle's pollution and emissions control equipment. If you care about keeping our planet's atmosphere clean, you'll want to make sure it's doing its job—for everyone's benefit.

Niel's Auto Service
49 Taylor Ct Ste B
Thousand Oaks, CA 91360
805-379-4040
http://www.nielsautoservice.net

Visibility Disaster! (Windshield Washer Pump Replacement)

Let's say you live in a cold climate where the snowy, icy weather challenges you to clear the salt and debris tossed up on your windshield.  You push your windshield washer switch expecting a good stream of fluid so the blades can wipe the glass clean. Yet nothing comes out.  Nada, zip.  What's going on? You know you filled up the windshield washer reservoir within the last week or so. 

Well, there could be a few things causing your windshield washing system to fail.  One culprit? The hoses that are supposed to carry that fluid from the washer pump to the spray nozzles may be frozen, or maybe they're cracked and leaking. It could be the nozzles themselves are stopped up, either iced up or jammed full of debris.  Your windshield wiper/washer switch could be worn out or the electrical system may not be conducting power to the washer pump. 

It's important that this system work properly, especially on days when the sun may be in front of you and your windshield is covered with a cloudy, icy mess.  Seeing what's going on in front of you may be like trying to peer through frosted glass, and that's not a safe situation for you or the drivers around you. You need to have this checked out by a technician as soon as you can.

Let's say the technician discovers it's not any of those components.  Turns out it's the electric windshield washer pump itself that's failed. After replacing it, everything is working fine, and you can see again.  As so often is the case with today's complex vehicles, figuring out the root cause of a problem can be tricky.  Rely on your vehicle service facility since they have the know how and diagnostic equipment to make sure your view of the road will always be crystal clear.

Niel's Auto Service
49 Taylor Ct Ste B
Thousand Oaks, CA 91360
805-379-4040
http://www.nielsautoservice.net

Start Me Up (Ignition Systems)

When you start up your gasoline engine car, you may not know that it's using the same ignition principles as it has for decades.  You have spark plugs that require enough power so a spark can jump across a gap at its tip.  Years ago, a vehicle's 12-volt system had to produce 15,000-25,000 volts to do that, so engineers came up with something called an ignition coil that bumps up the voltage. It also has to be done at just the right interval called timing.

The first systems had a distributor, a mechanical device with a rotating disc that switched the power to the ignition coil on and off.  That higher voltage then was sent to the spark plugs at the correct time interval. But the mechanical "points" had to be replaced and adjusted every 12,000 miles/20,000 kilometers.  Engineers later replaced the switching mechanism with solid state ones, but they still needed replacement after 120,000 miles/200,000 kilometers.

The next evolution came in the 80's when the distributor was replaced with a couple of sensors which talked to a computer.  This "DIS" (distributor-less automotive ignition system) was a big advance.  Plus, it didn't use just one ignition coil for all the cylinders.  It had coil "packs" that each provided spark to two cylinders.  That way, the voltage could be boosted even higher, to 30,000 volts, which helped engines be able to ignite a leaner fuel/air mixture.

Recently have come even more improvements.  Now instead of coil packs, there's a coil that's attached to each spark plug.  No more spark plug wires means less maintenance. Plus, a stronger, hotter spark of 50,000 volts can make an engine more reliable, increase fuel economy and reduce emissions.

No matter what ignition system your vehicle uses, your vehicle service facility has a staff of technicians trained to work on the latest technology.  Make sure to have your vehicle maintained regularly so you can take full advantage of these modern engineering marvels.

Niel's Auto Service
49 Taylor Ct Ste B
Thousand Oaks, CA 91360
805-379-4040
http://www.nielsautoservice.net